|
Push rod built and installed
|
Forward bell crank installed |
|
Rear bell crank assembled and push rod installed |
Push rod rubbing bulkhead |
|
Rear bell crank installation |
Drilling rudder brackets |
|
Rudder pedals and brake pedals and tank support |
Improperly installation to be refitted |
Relocation of cross-member
|
Correct location |
1/4 inch too short |
Rear control rod bracket |
Throttle handle coming soon |
Counter sink wrong, must replace lever |
Proper fit of control rod and rudder cables
|
New lever installed, but wrong angle, must do again |
Install cables |
Parts for yoke?
|
Landing gear cables
|
New bushing installed. Excellent fit.
|
| |
|
| |
|
| |
|
| |
|
| |
|
| |
|
